Compaq 2000fc Instrukcja Naprawy Pobierz pdf (Strona 33)

Quick Troubleshooting Guide A-3

Diskette Drive

Problem Possible Solution

Diskette drive light stays on. 1. Diskette is damaged. In Windows 95 or 98, run ScanDisk. In

Windows NT, run Error-checking.

2. Diskette is incorrectly inserted. Remove the diskette and reinsert.

3. Software program may be damaged. Check the program diskettes.

4. Drive button is not pushed in. Push in drive button.

5. Drive cable is not properly connected. Reconnect drive cable.

Diskette drive cannot write to

a diskette.

1. Diskette is not formatted. Format the diskette.

2. Diskette is write-protected. Either use another diskette that is not

write-protected or disable the write protection on the diskette.

3. Writing to the wrong drive. Check the drive letter in the path

statement.

4. Not enough space is left on the diskette. Use another diskette.

5. Diskette write control is enabled. Check the Removable Media

write settings in Computer Setup.

Cannot format diskette. Invalid media reported. When formatting a diskette in DOS, you may

need to specify diskette capacity. For example, to format a 1.44-MB

diskette, type the following command at the DOS prompt:

FORMAT A:/F:1440

Diskette drive cannot read a

diskette.

1. Diskette is not formatted. Format the diskette.

2. Using the wrong diskette type for the drive type. Check the drive

type and use a compatible diskette.

3. Reading the wrong drive. Check the drive letter in the path

statement.

4. Diskette drive has been disabled by Computer Setup, Windows

NT, Windows 95, or Windows 98 utilities. Run Computer Setup

and enable the diskette drive.

A problem has occurred with a

disk transaction.

The directory structure is bad, or there is a problem with a file. Run

ScanDisk.

Non-system disk message. The system is trying to start from a nonsystem diskette. Remove the

diskette from the drive.

Drive not found. 1. Check the cables for loose connections.

2. If a second diskette drive has been installed, follow the computer

reconfiguration directions in the “Hardware Installation Problems”

section.

3. See Flowchart 18.

System has misidentified the

diskette drive type.

If a diskette drive other than a 3.5-inch, 1.44-MB drive has been

installed, ensure that the drive type is identified correctly under

Computer Setup.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

Compaq 2000fc Instrukcja Naprawy Strona 33

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Części komputerowe Compaq 2000fc