Compaq 4000S Dokumentacja Pobierz pdf (Strona 75)

4. Rotate the drive cage back down to its normal position.

Figure 6-29 Rotating the Drive Cage Down

5. Slide the drive back until it stops, then lift it up and out of the drive cage.

Figure 6-30 Removing a 3.5-inch Drive (Media Card Reader Shown)

NOTE: When replacing a 3.5-inch drive, transfer the four mounting screws from the old drive to the

new one.

Installing a Drive into the 3.5-inch Internal Drive Bay

The 3.5-inch bay is located underneath the 5.25-inch drive. To install a drive into the 3.5-inch bay:

1. Follow the procedure in

Removing an Internal 5.25-inch Drive on page 59 to remove the 5.25-

inch drive and access the 3.5-inch drive bay.

CAUTION: Ensure that the computer is turned off and that the power cord is disconnected

from the electrical outlet before proceeding.

2. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then

remove the bezel blank. See

Bezel Blanks on page 43 for more information.

Drives

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 187 188

Brak uwag

Compaq 4000S Dokumentacja Strona 75