Compaq 370 Instrukcja Naprawy Pobierz pdf (Strona 4)

Setup and configuration guidelines

4 Compaq ProLiant ML370 G2 Document Part Number: 86-0935761-C

Setup and configuration guidelines

This section defines how to verify that the Compaq ProLiant ML370 G2 hardware settings are correct

for a Secure Computing firewall. These instructions supplement the manufacturer’s Users Guide and

Installation and Troubleshooting Guide.

Remove the top cover.

Note: For the following steps, it will be advantageous to consult the Compaq Installation Guide for component

locations.

2. Install a network card into any PCI slot.

3. The embedded NIC can be used for a network connection.

4. Locate the DAT drive and verify the model number.

5. Figure 1 and Figure 2 show the jumper and switch settings for the Seagate STD2401LW.

11-12 9-10 7-8 5-6 3-4 1-2

1-2 = SCSI ID 0—jumper installed

3-4 = SCSI ID 1—jumper removed

5-6 = SCSI ID 2—jumper installed

7-8 = SCSI ID 3—jumper removed

9-10 = Parity checking—jumper installed

11-12 = Terminator Power—jumper removed

Note:Jumpers 1–8 are set to specify a SCSI ID of 5.

FIGURE 1. DAT DRIVE JUMPER SETTINGS FOR STD2401LW

These jumpers are located on

the back of the DAT drive.

S10 S9

S1 = Data compression (off) S9 = Wide narrow SCSI (on)

S2 = SCSI DC control (off) S10 = Inquiry string support (on)

S3 = Media recognition (on)

S4 = Self test (on)

S5 = Operating system configuration (on)

S6 = Operating system configuration (on)

S7 = Operating system configuration (on)

S8 = Operating system configuration (on)

FIGURE 2. DAT TAPE DRIVE SWITCH SETTINGS FOR STD2401LW

The switch pack is

located on the bottom of

the DAT drive.

1 2 3 4 5 6 7 8

Brak uwag

Compaq 370 Instrukcja Naprawy Strona 4