Compaq NetServer LP 2000r Przewodnik Instalacji

HP Server Novell NetWare Installation Guide Including 6.5 August 25, 2003 Objective The intent of this document is to provide you with key informati

For NetWare 5.1 5. After reading the License Agreement, highlight Accept License Agreement and press Enter. 6. Highlight Continue with Existing Part

the Platform Specific Module. Hot Plug support module may optionally display depending on whether or not your HP NetServer supports Hot Plug PCI. 17.

29. Select your time zone and click Next. 30. Choose whether to create a New NDS Tree or use and Existing NDS Tree and click Next. 31. Enter the Tre

LOAD C:\NWSERVER\DRIVERS\BKSTROSM.HAM LOAD C:\NWSERVER\DRIVERS\SCSIOSM.HAM 3. Restart the server and use the NWCONFIG utility to create the necessa

9. Change the prompt from Upgrade to New server and then arrow down to Continue and press the [enter] key. 10. Inspect Server Settings. If you do not

Type "load a:\<directory>\<driver_name>", then the installation program will prompt you to choose the slot number. At this poin

26. Repeat until all free space is allocated and select Next to continue. 27. Highlight the network board and specify the protocol. Once all Network b

Preparing for a new installation Please visit the following hp website for the latest supported BIOS, Firmware, and Driver versions for Netware 6.5:

Performing a new installation Inspect the system to confirm that it meets the minimum RAM and disk space requirements needed for installation. 1. Pow

17. The NetWare 6.5 installation will begin the preliminary DOS file copy. When complete, select and load the proper drivers for the following subsyst

Section 1. Novell NetWare Installation Overview Installing NetWare on your network server requires two major steps: Step 1: Preparing the bootable de

27. Select the proper time zone for the server installation. 28. Ensure that the proper time has been configured on the system prior to NetWare 6.5 in

For more details on the REGISTER MEMORY command, please refer to your NetWare System Administration manual. Tip #2. Installing NetWare 6.5 on a 4 GB

Table 9. Web resources Resource description Web address HP and Novell Partnership site http://h18000.www1.hp.com/products/servers/software/novell/in

3. Once at the NetServer Navigator Main Menu, verify information in top right corner of the screen, and then select Diskette Library. 4. Select the

Copy A:\CDROMDRV\IDEDOS\*.* C:\directoryname 8. Use the edit utility to add the following lines to your CONFIG.SYS file: DEVICE=C:\directoryname\F

2. Boot the HP NetServer into DOS. 3. Create a directory named NWUPDATE. 4. Copy all drivers from the NOS Drivers disk to the NWUPDATE directory.

NOTE: You may receive the following message: Install found the following hardware but found more than one driver supporting this hardware: xxx.xxx

23. Once back at the Disk Partition Options, select Return to previous menu and repeat steps 18 through 26 until all devices are partitioned. 24. Afte

NOTE: Refer to the Novell Netware 4.2 installation procedures for all other installation issues. After completing the installation of Netware 4.2, you

Load bkstrosm.ham Load scsiosm.ham 4. Next, from the C:\nwserver command prompt enter: server 5. Use the NetWare install utility to create the n