Compaq LTE Elite Podręcznik Użytkownika Pobierz pdf (Strona 382)

100

101

1. Install the SCSI-2 drive (Section 9.15).

2. Connect the SCSI-2 signal and power cables (Figure F-2) as follows:

- Connect one end of the SCSI-2 signal cable [1] to the connector on the

system board.

- Connect the other end [2] to the connector on the rear of the drive.

- Connect the outside connector of the drive power cable [3] to the

connector on the rear of the drive.

- Be sure that the other end of the drive power cable [4] is connected

to the vertical circuit board.

NOTE: Cables and connectors are keyed to allow only a correct match.

Connectors on the drive may be in a different location than those

shown.

3. Replace the bottom cover on the expansion base.

4. If a Class 1 Laser label accompanied the SCSI-2 drive, attach the label

near the nameplate label on the bottom cover of the expansion base for

regulatory compliance. Do not block any ventilation openings.

1 2 ... 377 378 379 380 381 382 383 384 385 386 387

Komentarze do niniejszej Instrukcji

Brak uwag

Compaq LTE Elite Podręcznik Użytkownika Strona 382

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Części komputerowe Compaq LTE Elite